Genea Biomedx Geri Installation Guide

For Status Monitoring:

Step 1: Equipment needed 

-    Airo Sensor 202041

-    External Status Adapter 

Step 2: Find Geri External Alarm Contact

The External Alarm Contact is located at the back of the unit.

Step 3: Link Geri to ViGIE 

Connect the NO (Normally Open) Geri Alarm Contact to the External Status Adapter to the Airo Sensor 202041

Additional Info: Please use the NO (Normally Open) Alarm Contact.

Step 4: Configure an alarm and perform a test 

1st - Find your sensor using the ViGIE Platform and configure an alarm profile.

2nd - Check if the Geri status match the ViGIE platform

Geri OK = ViGIE OK

If the status is mismatched (eg: Equipment Alarm but ViGIE OK) please raise a ticket with ViGIE Helpdesk Team
.
To: helpdesk@vigiesolutions.com
Subject: Status Sensor Label Swap

My Airo Sensor 202041 with Serial Number: (please fill in) needs a Label Swap.

3rd - Simulate an event

After simulate an event, please ensure that a new ViGIE Alarm was created/sent. 

Then a recovery should be tested as well, performing a status follow-up using ViGIE Platform.

This device will alarm if power has not been restored in approximately 100 seconds.

For External Probe Monitoring:

Find the external temperature probe port then insert the probe.