Esco Miri Installation Guide

Step 1: Equipment needed 

-    Airo Sensor 202041

-    External Status Adapter (pre-assembled with 3.5mm Jack)

Step 2: Find Esco Miri external alarm port 

The Alarm Port is located at the back of the unit.

Step 3: Link Esco Miri to ViGIE 

Connect the 3.5mm Jack to Esco Miri and the External Status Adapter to the Airo Sensor 202041

Additional Info: The output is NC (Normally Closed) and non configurable.

Step 4: Configure an alarm and perform a test 

1st - Find your sensor using the ViGIE Platform and configure an alarm profile.

2nd - Check if the Esco Miri status match the ViGIE platform

Esco Miri OK = ViGIE OK

If the status is mismatched (eg: Equipment Alarm but ViGIE OK) please raise a ticket with ViGIE Helpdesk Team
.
To: helpdesk@vigiesolutions.com
Subject: Status Sensor Label Swap

My Airo Sensor 202041 with Serial Number: (please fill in) needs a Label Swap.

3rd - Simulate an event

After simulate an event, please ensure that a new ViGIE Alarm was created/sent. 

Then a recovery should be tested as well, performing a status follow-up using ViGIE Platform.

This device will alarm if : 
- Temperature alarm
- Gas alarm for CO2 or O2 levels
- Low-pressure or high-pressure alarm for CO2 and N2 gases  
- Power supply to the unit is suddenly cut