Astec EC9 Installation Guide

Status Monitoring:

Step 1: Equipment needed 

-    Airo Sensor 202041

-    Astec EC9 Equipment Status Cable/Adapter

Step 2: Find EC9 external alarm port 

The Alarm Port is located at the back of the unit.

Step 3: Link Astec EC9 to ViGIE 

Connect the Astec EC9 and the External Status Adapter to the Airo Sensor 202041 External adapter, using the NO (Normally Open) contacts.

Step 4: Configure an alarm and perform a test 

1st - Find your sensor using the ViGIE Platform and configure an alarm profile.

2nd - Check if the Astec EC6 status match the ViGIE platform

Astec EC9  = ViGIE OK

If the status is mismatched (eg: Equipment Alarm but ViGIE OK) please raise a ticket with ViGIE Helpdesk Team
.
To: helpdesk@vigiesolutions.com
Subject: Status Sensor Label Swap

My Airo Sensor 202041 with Serial Number: (please fill in) needs a Label Swap.

3rd - Simulate an event

After simulate an event, please ensure that a new ViGIE Alarm was created/sent. 

Then a recovery should be tested as well, performing a status follow-up using ViGIE Platform.

Whenever the equipment alarms, the external alarm output will be activated

Analog Monitoring:

Find the 18 Pin Port and link the connector.