Astec CCM-iBIS Installation Guide

Status Monitoring:

Step 1: Equipment needed 

-    Airo Sensor 202041

-    Astec CCM-iBIS Equipment Status Cable/Adapter

Step 2: Find CCM-iBIS external alarm port 

The Alarm Port is located at the back of the unit.

Step 3: Link Astec CCM-iBIS to ViGIE 

Connect the Astec CCM-iBIS and the External Status Adapter to the Airo Sensor 202041 External adapter, using the NO (Normally Open) contacts.

Then the Adapter is ready to connect to the Analog Alarm Output from Astec CCM-iBIS .

Step 4: Configure an alarm and perform a test 

1st - Find your sensor using the ViGIE Platform and configure an alarm profile.

2nd - Check if the Astec CCM-iBIS status match the ViGIE platform

Astec CCM-iBIS  = ViGIE OK

If the status is mismatched (eg: Equipment Alarm but ViGIE OK) please raise a ticket with ViGIE Helpdesk Team
.
To: helpdesk@vigiesolutions.com
Subject: Status Sensor Label Swap

My Airo Sensor 202041 with Serial Number: (please fill in) needs a Label Swap.

3rd - Simulate an event

After simulate an event, please ensure that a new ViGIE Alarm was created/sent. 

Then a recovery should be tested as well, performing a status follow-up using ViGIE Platform.

Whenever the equipment alarms, the external alarm output will be activated.

Analog Monitoring:

Find the 18 Pin Port and link the connector.