K-Systems G210 Installation Guide
Step 1: Equipment needed
Step 2: Find G210 external alarm port
Step 3: Link G210 to ViGIE
Step 4: Configure an alarm and perform a test
Step 1: Equipment needed
- Airo Sensor 202041
- External Status Adapter (pre-assembled with 6 PIN XLR)
Step 2: Find G210 external alarm port
The Alarm Port is located at the back of the unit.
Step 3: Link G210 to ViGIE
Connect the 6 PIN XLR Connector to G210 and the External Status Adapter to the Airo Sensor 202041
Step 4: Configure an alarm and perform a test
1st - Find your sensor using the ViGIE Platform and configure an alarm profile.
2nd - Check if the G210 status match the ViGIE platform
G210 OK = ViGIE OK
If the status is mismatched (eg: Equipment Alarm but ViGIE OK) please raise a ticket with ViGIE Helpdesk Team
.
To: helpdesk@vigiesolutions.com
Subject: Status Sensor Label Swap
My Airo Sensor 202041 with Serial Number: (please fill in) needs a Label Swap.3rd - Simulate an event
After simulate an event, please ensure that a new ViGIE Alarm was created/sent.
Then a recovery should be tested as well, performing a status follow-up using ViGIE Platform.
This device will alarm for : - Gas Alarm - Pressure Alarm - Temperature Alarm
Was this article helpful?
That’s Great!
Thank you for your feedback
Sorry! We couldn't be helpful
Thank you for your feedback
Feedback sent
We appreciate your effort and will try to fix the article